u-blox ZED-F9P User Manual

u-blox ZED-F9P Interface Description - Manual
Advance Information
LOG-FINDTIME continued
Byte Offset Number
Format
Scaling Name Unit Description
10 U1 - second - Second (0-60) of UTC time
11 U1 - reserved2 - Reserved
5.11.3.2 Response to FINDTIME request
Message
UBX-LOG-FINDTIME
Description
Response to FINDTIME request
Firmware
Supported on:
• u-blox 9 with protocol version 27
Type
Output
Comment
-
Header Class ID Length (Bytes) Payload Checksum
Message Structure
0xB5 0x62 0x21 0x0E 8
see below
CK_A CK_B
Payload Contents:
Byte Offset Number
Format
Scaling Name Unit Description
0 U1 - version - Message version (=1 for this version)
1 U1 - type - Message type, 1 for response
2 U1[2] - reserved1 - Reserved
4 U4 - entryNumber - Index of the first log entry with time = given
time, otherwise index of the most recent entry
with time < given time. If 0xFFFFFFFF, no log
entry found with time <= given time. The
indexing of log entries is zero based.
5.11.4 UBX-LOG-INFO (0x21 0x08)
5.11.4.1 Poll for log information
Message
UBX-LOG-INFO
Description
Poll for log information
Firmware
Supported on:
• u-blox 9 with protocol version 27
Type
Poll Request
Comment
Upon sending of this message, the receiver returns UBX-LOG-INFO as defined below.
Header Class ID Length (Bytes) Payload Checksum
Message Structure
0xB5 0x62 0x21 0x08 0
see below
CK_A CK_B
No payload
UBX-18010854 - R04 Advance Information Page 95 of 259

u-blox ZED-F9P Specifications

General

GNSS	GPS, GLONASS, Galileo, BeiDou, QZSS, SBAS
Concurrent GNSS	4
RTK	Yes
Velocity Accuracy	0.05 m/s
Time Pulse Accuracy	30 ns
Operating Temperature	-40°C to +85°C
Supply Voltage	2.7 V to 3.6 V
Channels	184
Frequency Bands	L1, L2
Dimensions	22 mm x 17 mm x 2.4 mm
Interfaces	UART, SPI, I2C