u-blox ZED-F9P User Manual

u-blox ZED-F9P Interface Description - Manual
Advance Information
CFG-RINV continued
Byte Offset Number
Format
Scaling Name Unit Description
1 + 1*N U1 - data - Data to store/stored in Remote Inventory.
End of repeated block
Bitfield flags
This graphic explains the bits of flags
Name Description
dump
Dump data at startup. Does not work if flag binary is set.
binary
Data is binary.
5.9.21 UBX-CFG-RST (0x06 0x04)
5.9.21.1 Reset Receiver / Clear Backup Data Structures
Message
UBX-CFG-RST
Description
Reset Receiver / Clear Backup Data Structures
Firmware
Supported on:
• u-blox 9 with protocol version 27
Type
Command
Comment
Don't expect this message to be acknowledged by the receiver.
• Newer FW version won't acknowledge this message at all.
• Older FW version will acknowledge this message but the acknowledge may not be sent
completely before the receiver is reset.
Header Class ID Length (Bytes) Payload Checksum
Message Structure
0xB5 0x62 0x06 0x04 4
see below
CK_A CK_B
Payload Contents:
Byte Offset Number
Format
Scaling Name Unit Description
0 X2 - navBbrMask - BBR Sections to clear. The following Special Sets
apply:
0x0000 Hot start
0x0001 Warm start
0xFFFF Cold start (see graphic below)
UBX-18010854 - R04 Advance Information Page 76 of 259

u-blox ZED-F9P Specifications

General

GNSS	GPS, GLONASS, Galileo, BeiDou, QZSS, SBAS
Concurrent GNSS	4
RTK	Yes
Velocity Accuracy	0.05 m/s
Time Pulse Accuracy	30 ns
Operating Temperature	-40°C to +85°C
Supply Voltage	2.7 V to 3.6 V
Channels	184
Frequency Bands	L1, L2
Dimensions	22 mm x 17 mm x 2.4 mm
Interfaces	UART, SPI, I2C