u-blox ZED-F9P Interface Description - Manual
Advance Information
Name Description
ram
Update configuration in the RAM layer
bbr
Update configuration in the BBR layer
flash
Update configuration in the Flash layer
Bitfield transaction
This graphic explains the bits of transaction
Name Description
action
Transaction action to be applied:
0: Transactionless UBX-CFG-VALSET: In the next UBX-CFG-VALSET, it can be either 0 or 1. If a transaction has not
yet been started, the incoming configuration is applied (if valid). If a transaction has already been started, cancels
any started transaction and the incoming configuration is applied (if valid).
1: (Re)Start set transaction: In the next UBX-CFG-VALSET, it can be either 0, 1, 2 or 3. If a transaction has not yet
been started, a transaction will be started. If a transaction has already been started, restarts the transaction,
effectively removing all previous non-applied UBX-CFG-VALSET messages.
2: Set transaction ongoing: In the next UBX-CFG-VALSET, it can be either 0, 1, 2 or 3.
3: Apply and end a set transaction: In the next UBX-CFG-VALSET, it can be either 0 or 1.
UBX-18010854 - R04 Advance Information Page 89 of 259
To Next Page
Loading...
