• Uplink signals are signals used on the uplink cable between the IFDR and the control
panel.
Available WSR98D RVP test points:
0:<no-output 1:RF-Gate 2:RF-Pulse-Start
3:RF-Drive 4:Filament-Reset 5:Post-Charge
6:Mod-Charge 7:Mod-Discharge 8:Trig-Charge
9:Rx-Prot-Cmd 10:Rx-Prot-Rsp 11:Update-In
12:Udate-Time1 13:Ph-Coho-Sel 14:Uplink-Clk
15:Uplink-Data 16:Uplink-Sel
==> TP-1 and TP-2 are presently: (0,0)
RVP900 User Guide M211322EN-J
128
To Next Page
Loading...