Vaisala RVP900 - Test Checklist; Table 87 RVP Test Checklist

A.2 Test Checklist
Complete the installation checklist after installing the RVP.
Record all values when instructed. Save the values for future reference.
Table 87 RVP Test Checklist
Task Checked OK/Not
OK
Remarks
A.3 Installation Check (page 341)
A.4 Power Up Check (page 342)
A.5.1 Checking Terminal Setup (page 344)
A.6 Checking Internal Status with Setup V Command (page 344)
A.7 Checking Board Configuration with Setup Mc Command (page 345)
A.8 Checking Processing Options with Setup Mp Command (page 346)
A.9 Checking Clutter Filters with Setup Mf Command (page 347)
A.10 Checking General Trigger Setup with Setup Mt Command (page 347)
A.11 Initial Setup of Information for Each Pulse Width (page 349)
A.12 Checking Burst Pulse and AFC with Setup Mb Command (page 350)
A.13 Checking Debug Options with the M+ Command (page 351)
A.14 Checking Transmitter Phase Control with Setup Mz Command
(page 352)
A.15 Ascope Test (page 353)
A.16 Burst Pulse Alignment (page 354)
A.17 Bandwidth Filter Adjustment (page 355)
A.18 Digital AFC (DAFC) Alignment (Optional) (page 356)
A.19 MFC Functional Test and Tuning (Optional) (page 358)
A.20 AFC Functional Test (Optional) (page 359)
A.21 Checking Input IF Signal Level (page 360)
A.22 Checking Calibration and Dynamic Range (page 362)
A.23 Checking Receiver Bandwidth (page 363)
A.24 Checking Receiver Phase Noise (page 365)
A.25 Hardcopy and Backup of Final Setups (page 366)
A.26 RVP901 TxDAC Stand-alone Bench Test (page 367)
RVP900 User Guide M211322EN-J
340