Vaisala RVP900 - Host Computer Commands

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| <Spare> |Err|Ttf|Ntg| Input 6
|---------------------------------------------------|---|---|---|
The following XARGS input words are optional, only if Action=1 and hybrid pulse.
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
|0 0 | (MSB) Log of Measured Noise Level, puse 2 (LSB) | XARG 1
|------|--------------------------------------------------------|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| NOISE Level Standard Deviation, pulse 2 (in 1/100 of a dB) | XARG 2
|------|--------------------------------------------------------|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Ratio of Horizontal/Vertical Noise, pulse 2 (in 1/100 of a dB)| XARG 3
|------|--------------------------------------------------------|
These fault bits are outputted in the latched status GPARM word 9.
Ntg
No Trigger during noise measurement.
Ttf
Trigger too fast during noise measurement, that is, some of the noise sample bins
were positioned past the trigger range.
Err
Error detected during the SNOISE command.
8.8 Initiate Processing (PROC)
The PROC command controls the processing and output of radar data.
PROC is a single-word command that specifies the type of processing to be performed, and
the type of output to be generated.
Chapter 8 – Host Computer Commands
255