Characteristic Description
Sampling rate 50 ... 100 MHz
Saturation level +8.0 dBm @ 50 Ω
Optional single and dual
polarization wide dynamic range
>120 dB
Table 77 Phase Stability
Characteristic Description
Klystron Better than 0.1°
Magnetron (for 1.0 microsecond
pulse)
Better than 0.5°
Table 78 IF Waveform Generator
Characteristic Description
Two 16-bit TxDAC outputs 5 ... 65 MHz
>65 dB SNR
+13dBm @ 50Ω
TxDDS output 5 ... 105 MHz
>65 dB SNR
+13dBm @ 50Ω
Table 79 RVP901 IFDR I/O
Characteristic Description
Analog input 6 dierential pairs ±10V
Signal must be low frequency with steps settling to 0.1% in 800
nanoseconds and a maximum sampling rate of 0.5 μsec.
AFC output • Digital AFC (DAFC) with up to 24 programmable output bits
• Automatic 2D (time/frequency) burst pulse search and fine-tracking
algorithms
Data output through Ethernet • 16-bit floating I and Q values
• 16-bit raw IF samples
RS-422 20 dierential line pairs
RVP901 to RVP902 link The IFDR is connected to RVP902 Signal Processor by a CAT5e cable (up
to 25 m in length), jumbo 8192-byte packets.
Each digital I/O line is configurable with over-voltage, ESD, and EFT
protection.
TTL/CMOS Lines 20 series terminated
RVP900 User Guide M211322EN-J
332
To Next Page
Loading...