Vaisala RVP900 - Setup Operating Parameters (SOPRM)

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Bits for ranges 0.000kmto 1.875km | Input 1
| | | | |
|---------------------------------------------------------------
\_1.875 \_0.000
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Bits for ranges 1022.000 km to1023.875 km | Input 512
| | | | |
|---------------------------------------------------------------
\_1023.875 \_1022.000
8.4 Setup Operating Parameters (SOPRM)
Use SOPRM to configure the signal processor. You must issue SOPRM when any of the
parameters in the list change.
The default parameter list consists of 20, 16-bit input words. These can be followed by
optional XARG parameters as needed.
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | |
| |NTH| | 0 0 0 1 0 | Command
|--------------------------|---|------------|-------------------|
If Nth is 1, then no threshold values are set. This means the system ignores input words 4, 5,
6, 7, 11, 12, 13, 14, and 18. This is usually used with the THRESH command when setting
individual thresholds. See 8.30 Set Individual Thresholds (THRESH) (page 315).
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| Sample Size | Input 1
|--------------------------|---|------------|-------------------|
The sample size is continually adjustable from 1 ... 256 pulses. In the alternating polarization
mode, the sample size must be even, if an odd value is entered, it is rounded up by one.
Chapter 8 – Host Computer Commands
239