G.6.4 ASR9-WSP Panel Indicators and Switches
The RCP903 Panel has several ASR9-WSP-specific indicators as well as some general status
indicator and control switches.
Table 130 ASR9-WSP Panel Indicators and Switches
Label Location Type Description
DATA Between J1 and J2 Green LED When enabled, blinks when data is being
transmitted on the 6-Level Weather
Interface
IDLE Between J1 and J2 Green LED When enabled, blinks when idle patterns
are being transmitted on the 6-Level
Weather Interface
RCP Between J4 and J5 Red LED RCP and Status signals blink slowly in
unison when boot image is running. When
application image is running, status
indicator is solid green and RCP indicator
is blinking red.
STATUS Between J4 and J5 Green LED
1, 2, 3, 4 Between J6 and J7 Green LED Programmable to display ASR9-WSP test
or debug status.
DIAG Between J5 and J6 Momentary Push
Button
When pressed, forces the panel into boot
mode.
ADDR Between J6 and J7 Momentary Push
Button
When pressed, forces the IP address of the
panel to its default value, 10.0.1.253
G.6.5 J1 - ASR9 Interface WSP #1
Table 131 Pin-out for J1 ASR9 / WSP #1
Pin
Number
Ribbon
Cable
Number
Signal Name Type Direction Description
1 1
WP_PRG_RXD
RS-232 Input Primary Serial
link to ASR9
34 2
WP_PRG_TXD
RS-232 Output Primary Serial
link to ASR9
18,2 3,4
WP_6WX_TD_P/N
RS-422 Output 6-level WX Sync
Data
35,19 5,6
WP_CX103_P/N
RS-422 Output Switch #103
control
3,36 7,8
WP_CX104_P/N
RS-422 Output Switch #104
control
RVP900 User Guide M211322EN-J
442
To Next Page
Loading...