Vaisala RVP900 - Appendix A: Installation and Test Procedures; Installation and Test Procedure Overview

Appendix A. Installation and
Test Procedures
A.1 Installation and Test Procedure
Overview
Record all values when instructed. Save the values for future reference.
Customer
Main Serial Number
IFDR Serial Number
Delivery Date
Radar Mfg./Type
Customer Engineer
Vaisala Engineer
These installation and test procedures are for Vaisala field engineers and customers
installing and testing of RVP900 on a radar system.
Complete these procedures in the order described. Failure to perform one step may eect
later tests.
Keep a copy of the test results either on
file or with this manual. Do not write in this manual
since it is replaced with an upgrade. Make a copy.
Sign-o on each test when it is complete. If a test does not pass, remedy the problem and
repeat the test. If the test still does not pass, add a sheet to the test explaining the variance.
A supplementary test sheet is at the end of the test procedure.
When you have successfully completed the installation and test procedures, your RVP900 is
ready to connect to your software application, such as the Vaisala IRIS system. Perform the
additional
configuration and calibration procedures before using the RVP900 with the
software.
Contact Vaisala technical support if you have problems or comments regarding this product
or procedures.
Appendix A – Installation and Test Procedures
339