4. Print the file or ftp it to a computer that supports a printer.
/usr/sigmet/config Hardcopy Listings
1. Print the following
files or ftp them to a computer that supports printing:
• setup_dsp.conf
• rvp900.conf
• softplane_dsp.conf
Backup /usr/sigmet/config directory
Checklist
Table 110 Backup and Hardcopy Checklist
Task Checked OK/Not OK Remarks
Test procedure completed successfully.
Test Passed
For Customer Date:
For Vaisala Date:
A.26 RVP901 TxDAC Stand-alone Bench
Test
Test Goal
Verify that the RVP901 TxDAC electrical I/O is working properly in an isolated environment.
Test Equipment
IRIS dspx utility
IF signal generator
Test Procedure
1. Enter the TTY setups through dspx.
2. Run dspx and temporarily revert to factory settings with f.
3. In the Mb menu, choose an intermediate frequency that matches the RVP901 analog
output filters (for example, 60 MHz) and a Blackman window.
Receiver Intermediate Frequency: 60.0000 MHz
Design/Analysis Window– 0:Rect, 1:Hamming, 2:Blackman : 2
Appendix A – Installation and Test Procedures
367
To Next Page
Loading...