1-80 Engine Mechanical Industrial 1.6L
Installation Procedure
1. Oil pump cover to oil pump.
Tighten
Tightening torque 6 Nm / 4 lb. ft.
2. Install safety valve with new seal ring in oil pump.
Tighten
Tightening torque 50 Nm / 37 lb. ft.
3. Install oil pump – see operation Oil Pump, Remove and
Install.
4. Install rear toothed belt cover – see operation Toothed
Belt Cover – Rear, Remove and Install.
5. Install toothed belt tension roller – see operation Toothed
Belt Tension Roller, Remove and Install.
6. Install toothed belt – see operation Toothed Belt, Re-
move and Install.
7. Install lower part of toothed belt cover – see operation
Toothed Belt Cover – Lower Part, Remove and Install.
8. Install ribbed V–belt – see operation Ribbed V–belt,
Remove and Install.
9. Install upper part of toothed belt cover – see operation
Toothed Belt Cover – Upper Part, Remove and Install.
10. Install oil pan – see operation Oil Pan, Remove and
Install.
To Next Page
Loading...