Industrial 1.6L Engine Mechanical 1-45
Installation Procedure
1. Coat sliding surfaces of the camshaft with MoS2 lubri-
cating paste (grey), insert camshaft in camshaft housing.
2. Install pressure plate on camshaft housing.
Tighten
Tightening torque: 8 Nm / 6 lb. ft.
3. Lightly coat sealing lip of front seal ring with silicon
grease (white). Install new front seal ring with KM–422 in
camshaft housing – use bolt and washer of camshaft pul-
ley.
4. Attach carrier plate to camshaft housing – see operation
Seal Ring in Rear Camshaft Housing, Replace.
5. Attach DIS ignition module – see operation DIS Ignition
Module, Remove and Install.
Camshaft Housing, Replace
Removal Procedure
1. Remove upper part of toothed belt cover – see operation
Toothed Belt Cover – Upper Part, Remove and Install.
2. Remove ribbed V–belts – see operation Ribbed V–belts,
Remove and Install.
3. Remove lower part of toothed belt cover – see operation
Toothed Belt Cover – Lower Part, Remove and Install.
4. Remove toothed belt – see operation Toothed Belt, Re-
move and Install.
5. Remove toothed belt tension roller – see operation Toothed
Belt Tension Roller, Remove and Install.
6. Rear toothed belt cover – see operation Toothed Belt
Cover – Rear, Remove and Install.
7. Detach or disconnect all wiring harness plugs, ground
connections and hose connections from intake manifold
see operation Intake Manifold, Remove and Install.
To Next Page
Loading...