Industrial 1.6L Engine Cooling 2-17
Installation Procedure
1. Coat the sealing surfaces of the water pump with
silicon (white) grease.
Important: When installing the water pump, align the
mark on the cylinder block (1) with the mark on the water
pump (2).
2. Position the water pump and a new sealing ring (4)
to the engine block.
Notice: Refer to Fastener Notice.
3. Install the water pump bolts (3) and washers.
Tighten
Tighten the water pump bolts to 8 N•m (6 lb ft).
4. Install the toothed belt rear cover. Refer to Section
1, Engine Mechanical.
5. Install the toothed belt tension roller. Refer to
Section 1, Engine Mechanical.
6. Install the toothed belt. Refer to Section 1, Engine
Mechanical.
7. Install the upper and lower toothed belt covers.
Refer to Section 1, Engine Mechanical.
8. Install the generator upper support bracket. Refer
to Section 3, Engine Electrical.
9. Install the cooling fan. Refer to Cooling Fan
Replacement.
10. Install the fan guard. Refer to Fan Guard
Replacement.
11. Install the drive belt. Refer to Drive Belt
Replacement.
12. Install the radiator upper support. Refer to Radiator
Replacement.
13. Fill the cooling system. Refer to Draining and Filling
Cooling System.
14. Start the engine and Check for leaks.
80362010
80362011
To Next Page
Loading...