Industrial 1.6L Engine Mechanical 1-31
Removal Procedure
1. Remove engine vent hose from camshaft housing cover.
2. Detach wiring trough from camshaft housing cover.
3. Remove camshaft housing cover from camshaft housing.
4. Remove camshaft sprocket (1) from camshaft –
counterhold with open–ended spanner on hex of cam-
shaft.
5. Edge out seal ring (2) with suitable tool.
Important: Do not damage sealing surfaces.
Installation Procedure
1. Lightly coat sealing lip of seal ring with silicon grease
(white).
2. Press seal ring with KM–422 (3) in camshaft housing –
use bolt and washer of camshaft pulley.
3. Attach camshaft sprocket to camshaft – counterhold
with open–ended spanner on hex of camshaft.
Tighten
Tightening torque 45 Nm / 33 lb. ft.
4. Install camshaft housing cover at camshaft housing.
Tighten
Tightening torque 8 Nm / 6 lb. ft.
5. Attach engine bleeding hose to camshaft housing cover.
6. Install toothed belt – see operation Toothed Belt, Re-
move and Install.
7. Install lower part of toothed belt cover – see operation
Toothed Belt Cover – Lower Part, Remove and Install.
8. Install ribbed V–belt – see operation Ribbed V–belt,
Remove and Install.
9. Install upper part of toothed belt cover – see operation
Toothed Belt Cover – Upper Part, Remove and Install.
To Next Page
Loading...