Maintenance
1132−2/A2
Winterthur Gas & Diesel Ltd.
19/ 19
15) After each installation of a new bearing shell, measure the crank deflection, refer to
3103−1.
16) Do a check of the oil supply to the main bearing.
7. Main Bearing − Lubrication
After an overhaul of the bearing shells, more lubricant can be added to prevent
damage to the surface of the bearing shells. Refer to the Operation Manual, 0750−1
Lubricating Oils.
1) To fill the bearing shell with the lubricant do the procedure that follows:
d) Remove the blank flange (6, Fig. 23).
e) Remove the screw plug (5).
f) Fill the bearing shell with the applicable lubricant.
2016
Main Bearing − Removal and Installation
To Next Page
Loading...
