Maintenance
5551−1/A1
Winterthur Gas & Diesel Ltd.
11/ 11
6. Completion
1) Attach the applicable oil inlet pipes (2, Fig.12) to the servo oil pumps.
2) Install the applicable HP servo oil pipes (1) to the servo oil pumps, refer to 8447−1
paragraph 5).
3) Connect the applicable electrical connections (3, 4, 5).
4) Remove all tools and lifting equipment from the work area.
5) Set to on the main bearing oil pump.
6) Set to on the service pump.
7) Do a check for leaks.
8) Set to off the service pump.
Fig. 12
1
2
4
5
3
WCH03058
2015
Servo Oil Pump − Removal and Installation
To Next Page
Loading...
