4. Slowly pull the Media Shaft from the core of the Media Roll.
5. Pinch the Green Lever again to insert the new Media Shaft into a new media roll. Be
sure the roll ends are aligned according to the Media Size Label.
6. Remove the manufacturer’s piece of tape holding the edge of the roll from unraveling.
NOTE
If when removing the tape from a new roll you see any remaining glue, wipe it
clean. This can cause misfeeds.
NOTE
If the media roll is damaged, trim the damaged edge with scissors before
proceeding to the next step.
WARNING
Be careful not to pinch your fingers when you set the roll media in the Media
Drawer.
1-29
Xerox
®
6279
®
Wide Format Solution
Copy/Scan User Guide
Product Overview
To Next Page
Loading...
