Xerox ColorQube 9303 Series - Page 79

February 2013
2-55
ColorQube® 9303 Family
05-258-00, 05-307-00
Status Indicator RAPs
05-258-00, 05-307-00 DADH Cover Interlock Open RAP
05-258-00 The DADH cover interlock switch detects that the top cover is open during initializa-
tion.
05-307-00 The DADH cover interlock switch detects that the top cover is open.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Remove all documents from the DADH.
• Check the switch actuator on the DADH cover, Figure 1. If the actuator is damaged, install
a new DADH top cover, PL 5.20 Item 15.
• Make sure the latch springs, PL 5.20 Item 7 are installed correctly. Make sure that the top
cover closes correctly. If necessary, install a new top access cover assembly, PL 5.20
Item 17.
• Check that the EPC memory PWB, PL 3.11 Item 21, is correctly seated.
Procedure
Enter dC330 code 05-212 to check the DADH cover interlock switch, Figure 1, S05-212. Actu-
ate S05-212. The display changes.
YN
Refer to WD 5.1. Check S05-212.
References:
• GP 13 How to Check a Switch.
• P/J187, DADH PWB.
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH cover interlock switch, PL 5.15 Item 11.
• DADH PWB, PL 5.10 Item 5.
Check that S05-212 is installed correctly.
Figure 1 Component location
DADH cover interlock switch,
S05-212
Actuator