Xerox ColorQube 9303 Series - Page 80

February 2013
2-56
ColorQube® 9303 Family
05-259-00, 05-260-00, 05-300-00
Status Indicator RAPs
05-259-00, 05-260-00 DADH Active Line or Standby Error
RAP
05-259-00 The DADH active line is in the wrong state during the scan
05-260-00 The DADH is not in standby at the start of the job.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Switch off, then switch on the machine, GP 14.
Procedure
1. Refer to WD 5.2 and WD 6.1. Check the wiring between PJ188 on the DADH PWB and
PJ921 on the scanner PWB. Repair the wiring as necessary, REP 1.1.
2. If necessary, install a new DADH PWB, PL 5.10 Item 5.
05-300-00 DADH Open RAP
05-300-00 The platen down sensor detects that the DADH is open during run.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Check that the DADH platen down sensor magnet, PL 5.10 Item 10 is installed and aligned
correctly to the platen down sensor.
NOTE: The DADH has two magnets, the magnet on the left front corner of the DADH actuates
the platen down sensor, refer to PL 5.10 Item 10.
Procedure
Enter dC330 code 62-019 to check the platen down sensor, Q62-019, PL 62.16 Item 5. Open
and close the DADH.
The display changes.
YN
Refer to WD 6.2. Check Q62-019.
References:
• GP 13 How to Check a Switch.
• PJ927, Scanner PWB.
• 01C +3.3V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Platen down sensor, PL 62.16 Item 5.
• Scanner PWB, PL 62.16 Item 8.
Perform the steps that follow. Install new components as necessary:
• Check that Q62-019 is installed correctly.
• Check the DADH frame for distortion, go to ADJ 5.2. If the DADH frame is distorted, install
a new DADH, PL 5.10 Item 9.