Xerox ColorQube 9303 Series - Page 90

February 2013
2-66
ColorQube® 9303 Family
05E
Status Indicator RAPs
05E Damaged Documents RAP
Use this RAP if the documents get damaged by the DADH.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. If the DADH damages the underside of the documents mid-way along the lead edge,
install a new feed roll assembly, PL 5.15 Item 1.
2. ADJ 5.2 DADH height adjustment.
3. Check the input tray for damage, PL 5.35 Item 1.
• Make sure that the document width guides move freely.
• Check that the takeaway roll assembly, PL 5.35 Item 17 and exit roll assembly, PL
5.35 Item 6 for damage and contamination, refer to ADJ 5.4.
• Check the restack arm for damage, PL 5.35 Item 3.
4. Open the DADH top access cover assembly, PL 5.20 Item 17.
• Check the document path for damage.
• Check the takeaway roll idlers and CVT roll idlers, PL 5.20 Item 3 for damage. Make
sure the idlers are clean and rotate freely, refer to ADJ 5.4.
5. Raise the DADH. Lower the baffle assembly, Figure 1.
• Remove any pieces of paper.
• Check the duplex gate, PL 5.25 Item 12 for damage. Make sure the duplex gate
moves freely.
• Check the CVT roll, PL 5.25 Item 5 for damage. If necessary, clean the CVT roll,
ADJ 5.4.
• Check the pre-scan idlers, PL 5.25 Item 6 and post scan idlers, PL 5.30 Item 4 for
damage. Make sure the idlers are clean and rotate freely, refer to ADJ 5.4.
• Check the document path for damage.
• Check the baffle assembly, PL 5.30 Item 14 for damage.
• Check the exit roll idlers for damage, PL 5.30 Item 6. Make sure the idlers are clean
and rotate freely, ADJ 5.4.
6. Check the CVT ramp assembly, PL 62.10 Item 5 for damage.
7. Make sure that the customers documents are within the specification, refer to GP 20.
Figure 1 Component location
Pre-scan idlers
Post scan idlers
Baffle assembly
Duplex gate
CVT roll