Xerox ColorQube 9303 Series - Page 89

February 2013
2-65
ColorQube® 9303 Family
05C, 05D
Status Indicator RAPs
05C DADH Motor Failure RAP
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Go to the correct procedure:
• DADH Feed Motor Failure
• DADH CVT Motor Failure
DADH Feed Motor Failure
NOTE: In duplex mode, the DADH feed motor runs in the forward and reverse direction. The
duplex mode component control code is provided to reverse the drive of the feed motor.
NOTE: When referring to WD 5.1, the Motor on (pulses) +24V indicated on PJ204, will read
+12V on a digital meter.
Refer to WD 5.1. Check the DADH feed motor, MOT05-074, PL 5.15 Item 16.
References:
• GP 10 How to Check a Motor.
• P/J181, DADH PWB and P/J204.
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH feed motor, PL 5.15 Item 16.
• DADH PWB, PL 5.10 Item 5.
DADH CVT Motor Failure
Refer to WD 5.1. Check the DADH CVT motor, MOT05-099, PL 5.25 Item 9.
NOTE: When referring to WD 5.1, the Motor on (pulses) +24V indicated on PJ203, will read
+12V on a digital meter.
References:
• GP 10 How to Check a Motor.
• P/J181, DADH PWB and P/J203.
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH CVT motor, PL 5.25 Item 9.
• DADH PWB, PL 5.10 Item 5.
05D DADH Feed Clutch Failure RAP
Use this RAP when the DADH feed clutch does not operate correctly.
Also use this RAP if the feed clutch energizes at the wrong time in duplex mode, which causes:
• Mis-feeds.
• The feed rolls to reverse and eject the original documents into the DADH input tray.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Refer to WD 5.1. Check the DADH feed clutch, CL05-062, PL 5.15 Item 9.
References:
• GP 12 How to Check a Solenoid or Clutch.
• P/J183, DADH PWB and P/J202.
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH feed clutch, PL 5.15 Item 9, or the alternative DADH feed clutch and spacer kit W/
TAG D-005, PL 5.15 Item 28.
• DADH PWB, PL 5.10 Item 5.
• DADH feed assembly, PL 5.15 Item 18.