Xerox ColorQube 9303 Series - Page 88

February 2013
2-64
ColorQube® 9303 Family
05A, 05B
Status Indicator RAPs
05A DADH Other Faults RAP
This RAP gives the additional information on common DADH problems. Perform the RAP for
all current fault codes before this RAP is performed.
Procedure
Go to the correct RAP:
• 05B DADH Document Sensor Failure RAP.
• 05C DADH Motor Failure RAP.
• 05D DADH Feed Clutch Failure RAP.
• 05E Damaged Documents RAP.
• 05F Platen Down Failure RAP.
05B DADH Document Sensor Failure RAP
Initial Actions
• Remove all documents from the DADH.
• Clean the DADH document sensor, PL 5.35 Item 19 and the area around the sensor.
• The DADH document sensor can fail to detect the last document in a document set if
static electricity is on the input tray. If necessary, clean the input tray with antistatic fluid,
refer to ADJ 5.4.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Enter dC330 code 05-102 to check the DADH document sensor, Q05-102, PL 5.35 Item 19.
The display changes.
YN
Refer to WD 5.1. Check Q05-102.
References:
• GP 11 How to Check a Sensor.
• P/J184, DADH PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH document sensor, PL 5.35 Item 19.
• DADH PWB, PL 5.10 Item 5.
If the problem continues, install new components as necessary:
• DADH document sensor, PL 5.35 Item 19.
• DADH PWB, PL 5.10 Item 5.