Yaesu FT2DR - Page 16

16
Before Using the Transceiver
Names and Functions of Controls
⑬
Displays squelch type (
see page 109)
TN: Lights when the tone encoder
function is enabled.
TSQ: Lights when the tone squelch
function is enabled.
DCS: Lights up when the DCS function is
enabled.
RTN: Lights when the reverse tone
function is enabled.
PR: Lights when the idle signal squelch
function is enabled.
PAG: Lights when the pager is enabled.
DC: Lights when the transceiver is set
to send the DCS code only during
transmission.
T-D: Lights when the transceiver is set
to send the CTCSS tone signal
during transmit, and wait for the
DCS code in receive mode.
D-T: Lights when the transceiver is
set to send the DCS code during
transmit, and wait for the CTCSS
tone signal in receive mode.
Displays the APRS baud rate (B-band only)
( APRS function Instruction manual).
⑭
Displays operation mode.
FM: FM (Analog) mode
: Auto mode (automatic switching
among Analog AM, Analog FM,
and Digital) *The display of the
“FM” portion differs according to
the selected mode.
DN: Wide digital mode (digital mode
using C4FM modulation)
VW: Wide digital mode (high-quality
digital communication)
⑮
appears when the bell function is active
( see page 114).