3-34
Digital Electronic Control
Digital Electronic Control
Digital Electronic Control system re-
set
A Digital Electronic Control system reset is re-
quired after the replacement of the Digital Elec-
tronic Control ECM or the engine ECM.
1. Connect the YDIS to display “Boat system”
menu. To connect and operate the YDIS,
see the YDIS (latest version) instruction
manual.
2. Click the “RC identification reset” button or
“OK” button, or select “RC identification re-
set” using the arrow keys, and then press
the Enter key on the keyboard.
3. Click the “Reset” button or press the Enter
key on the keyboard.
4. Click the “OK” button or press the Enter
key on the keyboard.
5. Click the “OK” button or press the Enter
key on the keyboard.
6. Turn the “POWER” switch to OFF, and
then remove the extension wire harness of
the Digital Electronic Control.
The outboard motor will automatically identify
the newly connected Digital Electronic Control
under any of the following conditions:
• When the extension wire harness is connect-
ed and the “POWER” switch is turned to ON
again.
• When the “POWER” switch is turned to OFF,
and then turned to ON again after waiting for
about 10 seconds until the power to the en-
gine ECM is shut off.
To Next Page
