3-3
Uncrating
Uncrating
Uncrating procedure
Wear gloves to avoid injury from sharp
steel edges while uncrating.
1. Check:
• Crate for shipping damage
Damage Consult your Yamaha distribu-
tor.
2. Remove:
• Top cover
•Frame
• Wrapping
Be careful not to damage the outboard mo-
tor.
3. Check:
• Outboard motor for concealed damage
Damage Consult your Yamaha distribu-
tor.
4. Remove:
• Top cowling
•Bolt “1”
• Air shroud cover “2”
5. Install:
• Special service tool “1”, “2”
When lifting the outboard motor, make sure
to use the specified special service tool.
Other bolts and hanging jigs could bend or
break, causing the outboard motor to fall.
6. Install:
• Lifting harness “1”
(to the lifting eye “2”)
7. Apply tension to the lifting harness.
2
1
1
Lifting eye “1”
90890-06953
Bolt hexagon with washer “2”
90890-06821
Bolt hexagon with washer “2”
YB-06821
Lifting eye bolt
36 N·m (3.6 kgf·m, 27 lb·ft)
1
2
2
1
To Next Page
