2-1
Electronic control system
Electronic control system
This model uses an electronic fuel injection control, digital ignition control, ETV control, VCT control,
knock control, over-revolution control, alert control, and fail-safe control.
The engine ECM performs these controls based on data received from each sensor and switch.
This model supports Digital Electronic Control. Shift-cut control and ETV control are performed based
on the signal from the Digital Electronic Control ECM.
The engine ECM is equipped with a self-diagnosis function. This function can be used to check trouble
codes on the YDIS.
It is also equipped with Y-COP as an anti-theft measure (optional).
To Next Page
