Yamaha F350B - Installing the Flywheel Magneto

7-16
Flywheel magneto
Installing the flywheel magneto
1. Install:
• Dowel
•Base
• Pulser coil
•Bracket
• Plastic tie
• Stator assembly
• Holder
• Dowel pin
2. Connect:
• Stator assembly coupler
• Pulser coil coupler
3. Install:
• Flywheel magneto
a. Install the flywheel magneto, and then
tighten new flywheel magneto bolts “1” to
the specified torques in 2 stages and in the
order [1], [2], and so on.
Apply force in the direction of the arrow to
prevent the special service tool “2” from
slipping off easily.
TIP:
In the second tightening stage for the flywheel
magneto bolts “1”, mark the bolts and flywheel
magneto with identification marks “a”, and then
tighten the bolts 90 from the marks on the fly-
wheel magneto.
Pulser coil bolt
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
New
T
R
.
.
90°
a
1
1
2
A
A. Conventional special service tool
(Worldwide)
B. Conventional special service tool (USA
and Canada)
C. New special service tool
90°
a
1
1
2
B
90°
a
1
3
1
3
C
[6]
[5]
[4]
[3]
[2]
[1]