2-30
Bracket unit
PTT TotalTilt™
This outboard motor is equipped with an automatic PTT tilt function. When this function is activated,
you can tilt the outboard motor up/down automatically by pressing the switch twice quickly instead of
keeping the PTT switch pushed.
The PTT TotalTilt™ function is available only when the engine is stopped. To prevent danger, the PTT
buzzer (power unit part) sounds to warn to the surrounding when the PTT TotalTilt™ function is oper-
ating.
When tilting up, the outboard motor stops at the set limiter position.
This function is deactivated by default. It can be activated or deactivated by changing the setting.
The PTT switch can be used not only on the remote control lever side, but also on the bottom cowling
side.
Activating and deactivating the PTT TotalTilt™ function
Make sure that all people are clear of the outboard motor when tilting the outboard motor up
and down. Body parts can be crushed between the outboard motor and the clamp bracket when
the outboard motor is trimmed or tilted.
1. Fully tilt the outboard motor down.
2. Remove the clip from the engine shut-off switch.
DN
UP
1. Engine shut-off switch
2. Clip
3. Engine shut-off cord (lanyard)
To Next Page
