5-2
Electrical component and wire harness routing
1. ETV (TPS)
2. Vapor shut-off valve
3. OCV (PORT)
4. Fuel injector
5. High-pressure fuel pump
6. Low-pressure fuel pump
A. Install the pulser coil coupler to the air
shroud.
B. Align the installation height of the clamp
with the installation position of the vapor
shut-off valve.
C. Install the holders to the intake manifold,
connect the fuel injector couplers, and
then fasten the fuel injector leads using
the holders.
D. Install the holders to the intake manifold
so that the catch of each holder is facing
up, and then fasten the main wire har-
ness using the holders.
E. Route the main wire harness by placing
it on the guide.
F. Install the YDIS coupler to the air
shroud.
G. Install the low-pressure fuel pump cou-
pler to the oil filler neck.
H. Be sure to fit the O-ring on the cam po-
sition sensor before fitting the coupler.
Be sure that the O-ring is compressed
by the cam position sensor and the cou-
pler.
I. Range in which to install the O-ring.
J. Install the clamp to the air shroud, and
then route the thermo sensor lead and
pulser coil lead.
K. Install the clamp as shown in the illustra-
tion.
L. Install the ground lead holding it against
the stopper.
To Next Page
