Name: Zebra TC75
Brand: Zebra
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Data Capture 5 - 7

Figure 5-9 Bluetooth Pairing Utility

5. Using the RS507, scan the bar code on the screen.

The RS507 emits a high/low/high/low beeps. The Scan LED flashes green indicating that the RS507 is

attempting to establish connection with the TC75. When connection is established, the Scan LED turns off and

the RS507 emits one string of low/high beeps.

6. On the TC75, touch .

Pairing the RS507 Hands-Free Imager Bluetooth HID

An RS507 Hands-free Imager can be used with the device to capture bar code data.

1. Ensure that Bluetooth is enabled on both devices.

2. Ensure that the Bluetooth device to discover is in discoverable mode.

3. Ensure that the two devices are within 10 meters (32.8 feet) of one another.

4. Place the RS507 in Human Interface Device (HID) mode. If the RS507 is already in HID mode, skip to step 5.

a. Remove the battery from the RS507.

b. Press and hold the Restore key.

c. Install the battery onto the RS507.

d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.

e. Scan the bar code below to place the RS507 in HID mode.

Zebra TC75 Specifications

General

Zebra TC75 User Manual

Other manuals for Zebra TC75