Configuration Guide
Stratus OCT User Manual PN 2660021134133 A
B-2
WARNING: The user bears responsibility for any source or target system
performance degradation or any other change or
defect resulting from the
attempt to perform these tasks.
WARNING: When networking the Stratus OCT, use only network cables with
an unshielded RJ-45 connector. Use of a
shielded network cable in the Stratus
OCT could result in electrical shock to the patient and/or examiner.
Terminology
The “source system” is the Stratus OCT system, from which you will export; the “target
system” is the review station PC to which you will export data.
Note: The choice and use of third party software on the target system for viewing
and analysis is at the user’s discretion. Carl Zeiss Meditec does not specify
compatible third party software, nor support its use.
Note: The instructions below are for a review station PC running Windows 2000 or
XP. If your intended target system is running another operating system, it may be
possible to configure it to import from the Stratus OCT, but the configuration
requirements may be different and are not explained here.
Data Transfer Overview: Import or Retrieve Data
To transfer Stratus OCT data to a PC running Stratus Review Software, you can either:
• Import a Stratus database from a network drive
or from a shared local folder to which
you have previously exported data using the Stratus OCT
Or
• Retrieve exams from an archive database, DVD-RAM, network drive, or DICOM server.
Note: See Configuration for Export via Preexisting Office Network (page B-3)
for instructions to set up data transfer fr
om the Stratus instrument to the review
station via a preexisting office network or Stratus to Review Station Direct
Network Connection (Crossover Cable) Instructions (page B-13) for tr
ansfer via
direct connection.
Importing or Retrieving from DVD-RAM
Note: To import or retrieve from a DVD-RAM, you must have a DVD-RAM drive
installed on the PC. Users are responsible for installation of a DVD-RAM drive on
their PC. Carl Zeiss Meditec does not provide or specify a DVD-RAM drive for the
user’s PC, nor support the installation and configuration of a DVD-RAM drive on the
user’s PC.
Importing from CD or DVD
Note: To import from CD or DVD, you must have installed on the importing PC both:
To Next Page
Loading...
