Stratus OCT User Manual PN 2660021134133 A
Printer Configuration Instructions
F-3
Network Configuration
Typically, no printer configuration is required for the network configuration. Three general
steps are required for configuration:
1. Connect the printer to the Stratus OCT via network cabling
2. Power on the printer
3. Install printer drivers on the Stratus OCT.
This is the usual sequence of steps, but follow the instructions provided with the approved
printer for details.
Using Network Cable(s) to Connect Stratus OCT and Printer
To establish network communication between the Stratus OCT and the printer, you can
directly connect instrument and printer with the network (ethernet) cable, or connect both
instrument and printer to the local area network or to a network switch/router/hub
connected to the Stratus OCT.
Note: Use the same kind of network cable in all cases. (If you connect instrument
and printer to the network rather than to each other, you will need two network
cables.) Do not use an RJ-45 crossover cable for direct connection between
instrument and printer.
USB Configuration
No printer configuration is required for the USB configuration. Three general steps are
required for configuration:
1. Install printer drivers on the Stratus OCT
2. Connect the printer to the Stratus OCT via USB
3. Power on the printer
However, the sequence of steps may vary. Follow the instructions provided with the
approved printer to observe the correct sequence of steps.
To Next Page
Loading...
