Zumtobel LITECOM - Page 113

Configuration
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 112
Condition: sunrise/sunset
The following table provides a description of the individual configuration options:
Parameter
Description
Effective range
Effective range (group, room or zone) in which the conditional scene recall
occurs.
Scene
Scene recalled by the conditional scene recall.
Fade time
The time it takes to change from the last value to the defined scene.
Sun position
Sun position (sunrise or sunset) at which the scene is recalled. The
information about sunrise and sunset is the result of the time and the
geographical coordinates defined in the basic settings.
For more information see Section Geographical coordinates
The sunrise/sunset time displayed is the time of the next sunrise or sunset.
This sunrise or sunset may not necessarily fall on the same day.
If polar day or polar night is defined, this information is displayed instead of
the time. During a polar day or night, the conditional scene recall is not
carried out.
i
Note
When the sunrise or sunset is calculated, a deviation of several
minutes may occur from a latitude greater than 80° (north and
south).
Offset
Value (in minutes) by which the conditional scene recall is corrected based
on the sunrise and sunset. When the value is positive, the conditional scene
recall is delayed by the selected time to occur at a time after sunrise or
sunset. When the value is negative, the conditional scene recall takes place
before sunrise or sunset.
Only if in
Additional condition that can be added if desired by enabling the tick mark.
Group, room or zone where a specific scene must be enabled in order for
the conditional scene recall to occur.
Scene
(Only for condition Only if in)
Scene that must be enabled in this group/room/zone.
And when in
Another additional condition that can be added if Only if in has been
specified. Tap the tick mark to enable the condition.
Group, room or zone where a specific scene must be enabled in order for
the conditional scene recall to occur.
Scene
(Only for condition And when in)
Scene that must be enabled in this group/room/zone.
Table 64:Configuration options – Conditional scene recall with condition “Sunrise/sunset”
58