Maintenance
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 172
Restoring data
When restoring the data, the RGA address, scene settings and device-specific settings (except for SEQUENCE
infinity) are applied to the field devices.
Note
When restoring data, you are not allowed to restore a data backup for a system with a newer
software version on a system with an older software version.
Path: App overview > Data backup
There are two ways to restore the data of your LITECOM system: restore data from a complete data backup or a
partial data backup.
Restoring data from a complete data backup
Requirement:
— The LITECOM CCD control device and computer or mobile device containing the desired data backup are
connected via an Ethernet cable or wireless access point.
Path: App overview > Data backup
1. Navigate to the path.
ÜThe Back up data and restore view is displayed.
2. In Section Complete data backup, tap the Restore button.
ÜThe pop-up window for file selection opens.
3. Navigate to the save location of the data backup and select the file.
ÜA compatibility check is performed.
ÜIf the data backup is compatible with the current software version, the data from
the data backup is written to the LITECOM system.This procedure may take
several minutes.
Note
If the data backup is not compatible with the current software version, a
corresponding message appears.
ÜUpdate software version.
ÜRestore data again.
ÜThe login screen is displayed.
4. Enter the user name admin.
To Next Page
Loading...