Configuration
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 61
7. Tap the tick mark as soon as all the necessary data has been changed.
ÜThe changes are saved.
ÜIf the old and new IP address are located in the same IP address range, the web
application is automatically redirected to the new IP address.
– or –
ÜIf the old and new IP address are located in different IP address ranges, the web
application is not automatically redirected to the new IP address. A corresponding
message is displayed.
Note
wOpen the web application in the browser using the new IP address.
Obtaining an IP address automatically
If a DHCP server is installed in your network, the LITECOM CCD control device can automatically obtain the IP
address via this server. The advantages of this are that you do not have to ensure that the IP address has already
been assigned in the network and any potential IP address conflicts are automatically resolved.
Path: App overview > Basic settings > Network settings
1. Navigate to the path.
ÜThe Change network settings view is displayed.
2. Enable the Obtain IP address automatically option.
ÜThe MAC address is displayed at the bottom.
3. Tap the tick mark.
ÜThe changes are saved.
ÜThe web application is not automatically redirected to the new IP address. A
corresponding message is displayed.
4. Request a new IP address from your IT manager.
5. Open the web application in the browser using the new IP address.
Note
When using a LITECOM-Touchpanel TCI, the new IP address must also
be adapted in the network settings of the touch panel.
Resetting the network settings to factory settings
You can reset the network settings at any time using the function key on the LITECOM CCD control device.
1. Press the function key.
2. Release the function key in the 3rd orange phase.
ÜThe network settings are reset to the factory settings.
To Next Page
Loading...