Zumtobel LITECOM - Page 93

Configuration
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 92
Function
Brief description
i
Note
Deleting a scene affects functions that use this scene in
their configuration (e.g. conditional scene recall,
presence linking). For this reason, check whether
existing functions will be affected after a scene is
deleted.
(3)
Create new scene
In addition to the five standard scenes, 16 extra scenes can be
created. When creating a scene, select a name and a scene icon.
i
Note
If SEQUENCE infinity are installed in your system, only
16 scenes in total can be created.
(4)
Select show
If you have created a show in the Shows app, you can set it here.
There is no show set by default.
i
Note
For more information see Shows manual
(5)
Save settings
As soon as you tap the cross, the changes are saved and the app
overview is displayed.
(6)
Configure scene
A scene can comprise different settings, depending on the devices
installed (e.g. intensity).
i
Note
· A description of the different icons can be found in
Section Icons .
· You can configure scenes for rooms.
For more information see Section Configuring scenes
for rooms
· You can configure scenes for zones.
For more information see Section Configuring scenes
for zones
· You can assign daylight linking to the scene.
For more information see manual Daylight linking
· You can assign a show to the scene.
For more information see manual Shows
· You can enable blind control for the scene.
For more information see manual Blind control
Table 47: Functions of the “Edit scene” view
178
93
99