MES3500 Series User’s Guide
113
CHAPTER 12
Filtering
This chapter discusses MAC address port filtering.
12.1 Configure a Filtering Rule
Configure the Switch to filter traffic based on the traffic’s source, destination MAC addresses and/or
VLAN group (ID).
Click Advanced Application > Filtering in the navigation panel to display the screen as shown
next.
Figure 55 Advanced Application > Filtering
The following table describes the related labels in this screen.
Table 28 Advanced Application > Filtering
LABEL DESCRIPTION
Active Make sure to select this check box to activate your rule. You may temporarily deactivate a rule
without deleting it by deselecting this check box.
Name Type a descriptive name (up to 32 printable ASCII characters) for this rule. This is for
identification only.
To Next Page
Loading...
