Chapter 17 Link Aggregation
MES3500 Series User’s Guide
147
17.4 Link Aggregation Setting
Click Advanced Application > Link Aggregation > Link Aggregation Setting to display the
screen shown next. See Section 17.1 on page 145 for more information on link aggregation.
Aggregator ID Link Aggregator ID consists of the following: system priority, MAC address, key, port priority
and port number. Refer to Section 17.2.1 on page 146 for more information on this field.
The ID displays only when there is a port belonging to this trunk group and LACP is also
enabled for this group.
Criteria This shows the outgoing traffic distribution algorithm used in this trunk group. Packets from
the same source and/or to the same destination are sent over the same link within the
trunk.
src-mac means the Switch distributes traffic based on the packet’s source MAC address.
dst-mac means the Switch distributes traffic based on the packet’s destination MAC
address.
src-dst-mac means the Switch distributes traffic based on a combination of the packet’s
source and destination MAC addresses.
src-ip means the Switch distributes traffic based on the packet’s source IP address.
dst-ip means the Switch distributes traffic based on the packet’s destination IP address.
src-dst-ip means the Switch distributes traffic based on a combination of the packet’s
source and destination IP addresses.
Status This field displays how these ports were added to the trunk group. It displays:
• Static - if the ports are configured as static members of a trunk group.
• LACP - if the ports are configured to join a trunk group via LACP.
Table 48 Advanced Application > Link Aggregation Status (continued)
LABEL DESCRIPTION
To Next Page
Loading...
