Chapter 6 Tutorials
MES3500 Series User’s Guide
62
6.5 How to Set Up a Guest VLAN
All ports on the Switch are in VLAN 1 by default. Say you enable IEEE 802.1x authentication on
ports 1 to 8. Clients that connect to these ports should provide the correct user name and password
in order to access the ports. You want to assign clients that connect to ports 1, 2 or 3 to a guest
VLAN (200 for example) before they can authenticate with the authentication server. In this guest
VLAN, clients can surf the Internet through the default gateway attached to port 10, but are not
allowed to access other network resources, such as the mail server or local data base.
6.5.1 Creating a Guest VLAN
Follow the steps below to configure port 1, 2, 3 and 10 as a member of VLAN 200.
1 Access the web configurator through the Switch’s port which is not in VLAN 200.
2 Go to Basic Setting > Switch Setup and set the VLAN type to 802.1Q. Click Apply to save the
settings to the run-time memory.
Internet
Guest VLAN 200
Ports 1, 2, 3 and 10
VLAN 1
To Next Page
Loading...
Need help?
General
