EasyManuals Logo

ZyXEL Communications MES3500 Series User Manual

ZyXEL Communications MES3500 Series
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #134 background imageLoading...
Page #134 background image
MES3500 Series User’s Guide
134
CHAPTER 14
Bandwidth Control
This chapter shows you how you can cap the maximum bandwidth using the Bandwidth Control
screen.
14.1 Bandwidth Control Overview
Bandwidth control means defining a maximum allowable bandwidth for incoming and/or out-going
traffic flows on a port.
14.1.1 CIR and PIR
The Committed Information Rate (CIR) is the guaranteed bandwidth for the incoming traffic flow on
a port. The Peak Information Rate (PIR) is the maximum bandwidth allowed for the incoming traffic
flow on a port when there is no network congestion.
The CIR and PIR should be set for all ports that use the same uplink bandwidth. If the CIR is
reached, packets are sent at the rate up to the PIR. When network congestion occurs, packets
through the ingress port exceeding the CIR will be marked for drop.
Note: The CIR should be less than the PIR.
Note: The sum of CIRs cannot be greater than or equal to the uplink bandwidth.
14.2 Bandwidth Control Setup
Click Advanced Application > Bandwidth Control in the navigation panel to bring up the screen
as shown next.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZyXEL Communications MES3500 Series and is the answer not in the manual?

ZyXEL Communications MES3500 Series Specifications

General IconGeneral
BrandZyXEL Communications
ModelMES3500 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals