Chapter 16 Mirroring
MES3500 Series User’s Guide
143
The following table describes the labels in this screen.
16.4 RMirror-Destination Screen
Use this screen to specify the RMirror VLAN ID and configure the monitor port when the Switch is
the destination device in remote port mirroring.
Click the RMirror-Destination link in the Mirroring screen. The following screen opens.
Table 44 Advanced Application > Mirroring > RMirror-Source
LABEL DESCRIPTION
Active Select this check box to enable the rule. Clear this check box to disable it.
RMirror VLAN ID Enter the ID number of the RMirror VLAN over which the mirrored traffic is forwarded.
Mirroring Port Select the number of the port that adds the RMirror VLAN tag to all mirrored traffic and
forwards traffic to other switch(es) in the same RMirror VLAN.
802.1 Priority Specify the priority of the mirrored traffic.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Mirrored Select this option to mirror the traffic on a port.
Direction Specify the direction of the traffic to mirror by selecting from the drop-down list box.
Choices are Egress (outgoing), Ingress (incoming) and Both.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the ID number of RMirror VLAN over which the mirrored traffic is
forwarded.
Active This field shows whether the rule is active or not.
802.1 Priority This field displays the priority of the mirrored traffic.
Mirrored Port
Ingress This field displays the number of port(s) on which the incoming traffic is mirrored.
Egress This field displays the number of port(s) on which the outgoing traffic is mirrored.
Both This field displays the number of port(s) on which the incoming and outgoing traffic is
mirrored.
Mirroring Port This field displays the number of the mirroring port in this RMirror VLAN.
Delete Check the rule(s) that you want to remove in the Delete column and then click the
Delete button.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
Need help?
General
