Chapter 29 VLAN Mapping
MES3500 Series User’s Guide
240
Figure 142 Advanced Application > VLAN Mapping
The following table describes the labels in this screen.
29.3 Configuring VLAN Mapping
Click the VLAN Mapping Configure link in the VLAN Mapping screen to display the screen as
shown. Use this screen to enable and edit the VLAN mapping rule(s).
Table 101 Advanced Application > VLAN Mapping
LABEL DESCRIPTION
Active Select this option to enable VLAN mapping on the Switch.
Port This field displays the port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the VLAN mapping feature on this port. Clear this check box to
disable the VLAN mapping feature.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
Need help?
General
