Chapter 42 Syslog
MES3500 Series User’s Guide
327
Figure 214 Management > Syslog
The following table describes the labels in this screen.
42.3 Syslog Server Setup
Click Management > Syslog > Syslog Server Setup to view the screen as shown next. Use this
screen to configure a list of external syslog servers.
Table 157 Management > Syslog
LABEL DESCRIPTION
Syslog Select Active to turn on syslog (system logging) and then configure the syslog setting.
Logging Type This column displays the names of the categories of logs that the device can generate.
Active Select this option to set the device to generate logs for the corresponding category.
Facility The log facility allows you to send logs to different files in the syslog server. Refer to the
documentation of your syslog program for more details.
Privilege Select a command privilege level. The Switch will only generate logs for commands that have
a privilege level greater than or equal to the specified privilege level.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
Need help?
General
