ZyXEL Communications MES3500 Series - Spanning Tree Protocol Status Screen; Spanning Tree Configuration

Chapter 13 Spanning Tree Protocol
MES3500 Series User’s Guide
120
13.2 Spanning Tree Protocol Status Screen
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click Advanced Application > Spanning Tree Protocol to see the
screen as shown.
Figure 61 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section for
each STP mode. Click Configuration to activate one of the STP standards on the Switch.
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch.
Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 62 Advanced Application > Spanning Tree Protocol > Configuration