Chapter 40 Access Control
MES3500 Series User’s Guide
313
40.3.7 Configuring SNMP User
From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 199 Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Active Select this check box to enable the sending of SNMP traps on this port. The Switch sends
the related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 150 Management > Access Control > SNMP > Trap Group > Port (continued)
LABEL DESCRIPTION
Table 151 Management > Access Control > SNMP > User
LABEL DESCRIPTION
User
Information
Note: Use the username and password of the login accounts you specify in this screen to
create accounts on the SNMP v3 manager.
Username Specify the username of a login account on the Switch.
To Next Page
Loading...
