ZyXEL Communications MES3500 Series - Configuring SNMP

Chapter 40 Access Control
MES3500 Series User’s Guide
309
40.3.4 Configuring SNMP
Click Management > Access Control > SNMP to view the screen as shown. Use this screen to
configure your SNMP settings.
Table 147 SNMP Switch Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
stp STPNewRoot 1.3.6.1.2.1.17.0.1 This trap is sent when the STP root switch
changes.
MRSTPNewRoot 1.3.6.1.4.1.890.1.5.8.68.36.2.1
1.3.6.1.4.1.890.1.5.8.57.36.2.1
1.3.6.1.4.1.890.1.5.8.80.36.2.1
This trap is sent when the MRSTP root switch
changes.
MSTPNewRoot 1.3.6.1.4.1.890.1.5.8.68.107.70.1
1.3.6.1.4.1.890.1.5.8.57.107.70.1
1.3.6.1.4.1.890.1.5.8.80.107.70.1
This trap is sent when the MSTP root switch
changes.
STPTopologyChange 1.3.6.1.2.1.17.0.2 This trap is sent when the STP topology
changes.
MRSTPTopologyChange 1.3.6.1.4.1.890.1.5.8.68.36.2.2
1.3.6.1.4.1.890.1.5.8.57.36.2.2
1.3.6.1.4.1.890.1.5.8.80.36.2.2
This trap is sent when the MRSTP topology
changes.
MSTPTopologyChange 1.3.6.1.4.1.890.1.5.8.68.107.70.2
1.3.6.1.4.1.890.1.5.8.57.107.70.2
1.3.6.1.4.1.890.1.5.8.80.107.70.2
This trap is sent when the MSTP root switch
changes.
mactable MacTableFullEventOn 1.3.6.1.4.1.890.1.5.8.68.27.2.1
1.3.6.1.4.1.890.1.5.8.57.27.2.1
1.3.6.1.4.1.890.1.5.8.80.27.2.1
This trap is sent when more than 99% of the
MAC table is used.
MacTableFullEventClear 1.3.6.1.4.1.890.1.5.8.68.27.2.2
1.3.6.1.4.1.890.1.5.8.57.27.2.2
1.3.6.1.4.1.890.1.5.8.80.27.2.2
This trap is sent when less than 95% of the
MAC table is used.
rmon RmonRisingAlarm 1.3.6.1.2.1.16.0.1 This trap is sent when a variable goes over
the RMON "rising" threshold.
RmonFallingAlarm 1.3.6.1.2.1.16.0.2 This trap is sent when the variable falls
below the RMON "falling" threshold.
cfm dot1agCfmFaultAlarm 1.3.111.2.802.1.1.8.0.1 The trap is sent when the Switch detects a
connectivity fault.