Chapter 25 Multicast
MES3500 Series User’s Guide
191
Figure 105 Advanced Application > Multicast > Multicast Setting
The following table describes the labels in this screen.
Table 73 Advanced Application > Multicast > Multicast Setting
LABEL DESCRIPTION
IGMP Snooping Use these settings to configure IGMP Snooping.
Mode The Switch supports IGMP version 1, IGMP version 2 and IGMP version 3.
Select the version of the IGMP packets that the Switch should use (Version2 or
Version3) to enable IGMP Snooping to forward group multicast traffic only to ports that
are members of that group. Otherwise, select Disable.
Querier Select this option to allow the Switch to send IGMP General Query messages to the VLANs
with the multicast hosts attached.
Host Timeout Specify the time (from 1 to 16 711 450) in seconds that elapses before the Switch
removes an IGMP group membership entry if it does not receive report messages from
the port.
802.1p
Priority
Select a priority level (0-7) to which the Switch changes the priority in outgoing IGMP
control packets. Otherwise, select No-Change to not replace the priority.
To Next Page
Loading...
