Chapter 26 AAA
MES3500 Series User’s Guide
209
Figure 120 Advanced Application > AAA > AAA Setup
The following table describes the labels in this screen.
Table 81 Advanced Application > AAA > AAA Setup
LABEL DESCRIPTION
Authentication Use this section to specify the methods used to authenticate users accessing the Switch.
Privilege Enable These fields specify which database the Switch should use (first, second and third) to
authenticate access privilege level for administrator accounts (users for Switch
management).
Configure the access privilege of accounts via commands (see the Ethernet Switch CLI
Reference Guide) for local authentication. The TACACS+ and RADIUS are external
servers. Before you specify the priority, make sure you have set up the corresponding
database correctly first.
You can specify up to three methods for the Switch to authenticate the access privilege
level of administrators. The Switch checks the methods in the order you configure them
(first Method 1, then Method 2 and finally Method 3). You must configure the settings in
the Method 1 field. If you want the Switch to check other sources for access privilege level
specify them in Method 2 and Method 3 fields.
Select local to have the Switch check the access privilege configured for local
authentication.
Select radius or tacacs+ to have the Switch check the access privilege via the external
servers.
To Next Page
Loading...
Need help?
General
