Chapter 27 IP Source Guard
MES3500 Series User’s Guide
221
Figure 124 Advanced Application > IP Source Guard > Static Binding
The following table describes the labels in this screen.
Table 88 Advanced Application > IP Source Guard > Static Binding
LABEL DESCRIPTION
MAC Address Enter the source MAC address in the binding.
IP Address Enter the IP address assigned to the MAC address in the binding.
VLAN Enter the source VLAN ID in the binding.
Port Specify the port(s) in the binding. If this binding has one port, select the first radio button
and enter the port number in the field to the right. If this binding applies to all ports, select
Any.
Add Click this to create the specified static binding or to update an existing one.
Cancel Click this to reset the values above based on the last selected static binding or, if not
applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each binding.
MAC Address This field displays the source MAC address in the binding.
IP Address This field displays the IP address assigned to the MAC address in the binding.
Lease This field displays how many days, hours, minutes, and seconds the binding is valid; for
example, 2d3h4m5s means the binding is still valid for 2 days, 3 hours, 4 minutes and 5
seconds. This field displays infinity if the binding is always valid (for example, a static
binding).
Type This field displays how the Switch learned the binding.
static: This binding was learned from information provided manually by an administrator.
VLAN This field displays the source VLAN ID in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies to
all ports.
Delete Check the entry(ies) that you want to remove and then click the Delete button to remove
the selected entry(ies) from the summary table.
Cancel Click this to clear the Delete check boxes above.
To Next Page
Loading...
